01-15-2015 09:03 AM
I am using vyatta 5400 on vmware for my SDN BCVRE learning. I have couple of queries below.
1. I do not see eth1/eth2/eth3 etc:- under show interfaces. I see only eth0 & loopback interface. Please help.
2. I do see in the router the default boot image. Do i need to upgrade this to any other image to do my exercise? If so please suggest the way out. I have received the license evaluation for free trial.
Please clarify these asap as my time is limited for the online training.
03-29-2015 06:59 AM
Were all VM NIC's added to the VM before the vRouter was installed, or was eth1, etc added afterwards?
I have just installed the vRouter on a VM that has 3 NIC's and all three are displayed, so perhaps if additional NIC's are added to the VM after the vRouter installation, then vRouter may not aut-detect them.