Management Software

Reply
New Contributor
Posts: 3
Registered: ‎11-23-2011

fabos not yet initialized

Checking system RAM - press any key to stop test

Checking memory address: 00100000

System RAM test using Default POST RAM Test succeeded.

set_bootstatus: BS_LOAD_OS, platform_idx = 1

Type run flash_nfs to mount root filesystem over NFS

Hit ESC to stop autoboot:  0
Map file at LBA sector 0x183e10
## Booting image at 00400000 ...
   Image Name:   Linux-2.6.14.2
   Image Type:   PowerPC Linux Multi-File Image (uncompressed)
   Data Size:    4269595 Bytes =  4.1 MB
   Load Address: 00000000
   Entry Point:  00000000
   Contents:
   Image 0:  3190917 Bytes =  3 MB
   Image 1:  1078663 Bytes =  1 MB
## Current stack ends at 0x1FAEEBE8 => set upper limit to 0x00C00000
## initrd at 0x0070B0D4 ... 0x0081265A (len=1078663=0x107587)
   Loading Ramdisk to 1f9e6000, end 1faed587 ... OK
 initrd_start = 1f9e6000, initrd_end = 1faed587
## Transferring control to Linux (at address 00000000) ...
Installing Linux 2.6 Kernel
Attempting to find a root file system on hda2...
INIT: version 2.78 booting
Bypassing firmware validation.
--- Partition /dev/hda1 is inconsistent.
--- Its content will be restored to be the same as that of /dev/hda2.
--- Please check the version and re-load firmware if necessary after the system boots up.
INIT: Entering runlevel: 3
Starting Fabric OS Services...
FIPS off, RRD...
**************************************************************
*                                                            *
* System booted     5 times within    3000 seconds!          *
*                                                            *
* Fabric OS has detected frequent switch reboot condition.   *
* Following actions can be taken to recover the switch:      *
* - remove or replace any problem blades (if applicable to   *
*   platform).                                               *
* - use supportsave to collect supportsave data.             *
*                                                            *
**************************************************************

login:

sysmodAttach open failed: No such device or address
fabsys device open: No such device or address
Raslog Module Initialisation failed rc=-1
fabsys device open: No such device or address

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.

vADC is now Pulse Secure
Download FREE NVMe eBook