For more details, please see ourCookie Policy.


Info & Feedback

Reply
New Member
Posts: 1
Registered: ‎04-20-2018

Command in vyatta 5400 to check if a specific flow has been allowed already?

[ Edited ]


Hello all,

I am looking for a command in Vyatta 5400 that allows me to check if a specific source and destination IP and port is being allowed by policies? In Juniper devices, the SRX firewalls have the command "show security match-policies from-zone XXXX to-zone XXX source-ip destination-ip destination-port" and other values you can add. It shows if a specific flow is allowed or not and also the policy name it hits. I have not found something similar in Vyatta yet. 

 


Any help will be appreciated. 

 

Post pulled from filter - moved to info and feedback @jason_cmgr

 

Community Manager
Posts: 259
Registered: ‎03-03-2014

Re: Command in vyatta 5400 to check if a specific flow has been allowed already?

@anmendez

 

The product you are referring to was acquired by one of the companies listed on this information page.

 

Please review >> https://community.brocade.com/t5/Info-Feedback/Brocade-Community-Forums-Redirects-to-Extreme-Networks-Pulse/m-p/94984/highlight/true#M194

 

Best Regards,

 

Jason M.
Brocade Community Manager
@jason_cmgr

 

 

Join the Broadcom Community

Get quick and easy access to valuable resources across the Broadcom Community Network.