08-30-2017 11:00 PM - edited 08-30-2017 11:03 PM
There is Brocade 6505.
Have single power supply configuration and on this power supply blinking green led and in switch logs appears these messages.
Wed Aug 23 2017 13:03:17 GMT+00:00 Error PS 1 set to faulty, rc=2000e. Chassis 901 1 EM-1034 SAN1 Wed Aug 23 2017 13:03:22 GMT+00:00 Warning Env Power Supply 1, is below low boundary(High=0, Low=1). Current value is 0 (1 OK/0 FAULTY). Switch 902 1 FW-1010 SAN1 Wed Aug 23 2017 13:03:22 GMT+00:00 Warning Switch status changed from HEALTHY to DOWN. Switch 903 1 FW-1424 SAN1 Wed Aug 23 2017 13:03:22 GMT+00:00 Warning Switch status change contributing factor Power supply: 1 bad, 1 absent. Switch 904 1 FW-1426 SAN1
But this power supply is still working and the switch has power.
What I can do to fix it?
08-30-2017 11:19 PM
this error message my be ignored on 6505.
most probable you have a old FOS installed, - what is the version installed ? -
I believe the defect was closed in higher release.
08-31-2017 12:06 AM
Right, defect is 564334, it is fixed in FOS version 7.4.1a and higher.
08-31-2017 12:28 AM - edited 08-31-2017 12:28 AM
This defect is fixed in 7.3.2 and higher versions in 7.3 code stream.
08-31-2017 12:30 AM
correct, you need to update to close the defect.
add to 7.4.1a as mentioned by Thierry, the defect is closed in follow FOS rel.
keep in mind to follow FOS target path if you want to upgrade from a current 7.3.0b to any higher rel. as 7.4.1a
upgrade/migration in one step from 7.3 to 8.0 is not supported.