01-25-2013 01:11 AM
I have Silkworm 200E switches that have not been in use, I want to put them in use now but I find it difficult logging into them using IPs that were set for them at a time. I want to rest the switches to factory default, can someone help please.
01-25-2013 01:55 AM
If you don't know configured IP, connect trough a Serial Port with admin credential
execute command "ipaddrshow" to verify configured IP
"ipaddrset" is th ecommand to set new IP Address.
01-25-2013 03:37 AM
Thanks for your reply, the main issue is connecting to the switch using serial port. I have used the serial cables that came with the switches but it is not helping. I aslo noticed some people had this problem but I have not seen how they went pass the problem.
01-25-2013 10:46 AM
--->>>I have used the serial cables that came with the switches but it is not helping.
If this is a Brocade Original Cable, shold have a Label with Part Number begin like as 50-00xxxxx-xx
--->>>I aslo noticed some people had this problem but I have not seen how they went pass the problem.
try with another serial cable.
BTW, make sure you have correct parameters settings and COM Port in PC/Notebook is working.