03-16-2017 12:38 PM
We bought a pair of EMC DS-5100B used off ebay.
When I received the switches, I found that the ports were not responding normally.
Index Port Address Media Speed State Proto ============================================== 0 0 030000 id N8 In_Sync FC Disabled (Incompatible port mode) 1 1 030100 id N8 No_Sync FC Disabled (Incompatible port mode)
I ran the portshow command and received the following output:
fs1:admin> portshow 0 portIndex: 0 portName: EQX_CORE_ISL portHealth: OFFLINE Authentication: None EX_Port Mode: Enabled Fabric ID: 40 Front Phantom: state = Not OK Pref Dom ID: 3 Fabric params: R_A_TOV: 0 E_D_TOV: 0 PID fmt: auto Authentication Type: None Hash Algorithm: N/A DH Group: N/A Edge fabric's primary wwn: N/A Edge fabric's version stamp: N/A portDisableReason: Incompatible port mode portCFlags: 0x0 portFlags: 0x4021 PRESENT U_PORT EX_PORT DISABLED LED LocalSwcFlags: 0x0 portType: 17.0 POD Port: Port is licensed portState: 2 Offline Protocol: FC portPhys: 6 In_Sync portScn: 2 Offline port generation number: 0 state transition count: 1 portId: 030000 portIfId: 4302000f portWwn: 20:00:00:05:1e:80:3e:35 portWwn of device(s) connected: Distance: normal portSpeed: N8Gbps LE domain: 0 FC Fastwrite: OFF Interrupts: 0 Link_failure: 0 Frjt: 0 Unknown: 0 Loss_of_sync: 1 Fbsy: 0 Lli: 7 Loss_of_sig: 2 Proc_rqrd: 6 Protocol_err: 0 Timed_out: 0 Invalid_word: 0 Rx_flushed: 0 Invalid_crc: 0 Tx_unavail: 0 Delim_err: 0 Free_buffer: 0 Address_err: 0 Overrun: 0 Lr_in: 1 Suspended: 0 Lr_out: 0 Parity_err: 0 Ols_in: 0 2_parity_err: 0 Ols_out: 1 CMI_bus_err: 0 Port part of other ADs: No
Not being well versed in Brocade CLI, I don't know the correct way to get these ports working.
Also, as an FYI, I cannot access the web URL for the switch. I believe there is some incompatability in thhe version of Jave being used, but I tried several versions and was not able to bring up any pages, so stuck with CLI at this time.
Solved! Go to Solution.
03-16-2017 01:38 PM
have you configured those Port or is this a preview config on the switch ?
if no do follow in order to set the port to default
about the WEB Tools, most probable you have JAVA issue, Depend what for FOS release is installed you need other JAVA Version, for details refer the Release Notes
->Not being well versed in Brocade CLI, I don't know the correct way to get these ports working.
Refer the Command Reference Manuals and Admin Guide.