02-09-2018 07:01 AM
I would like to use plink from my laptop to run a supportsave on a remote switch.
So i setup a cmd file as i normally would
plink USER@SWITCH -l USER -pw PASSWORD -m INPUTFILE >> OUTPUTFILE
The input file contains
supportsave -a -n -c
When i run the cmd file i get the following error
CRA is enabled. Only 'scp and sftp' protocols are supported
02-10-2018 07:33 AM
the answer is in the message output.
if CRA = Challenge Response Authentication is enable, only SCP and SFTP is supported.