04-26-2013 02:46 AM
Hi Team, morning.
We have two Brocade SAN Switch IBM 2498-B24.
We have changed the Management IP with a Serial Cable, the procedure was easy:
ipaddrset (we configured IP, Subnet and Gateway)
ipaddrshow (we saw the new config ok)
But when we try connect with the SAN Switch on the LAN dont connect; we tried again connect but this time with RJ 45 crossover cable with the same result, dont connect with the switch.
We have put the switches in a isolated Hub, in a isolated switch, and the same result, not connect.
We have used Telnet, Putty,...; differents Laptop with differents Win SO....
Is possible disable and enable the Management Ethernet Port only??? How to do this procedure?
We dont want reboot the SAN Switch.
Thanks in advance.