11-06-2009 06:57 AM
I have an old FC switch Silkworm3850 with FOS 5.0.4 with zone active in production enviroment.
I have purchesed a new FC switch DS-200B with FOS 6.1.1 and i want to join in one fabric with the old one, but a segmented (zone conflict) error occurs.
I think that I must upgrade FOS on the old FC switch but there are other things to check before this upgrade in order to resolv the problem?
Switches have different DomainIDs.
At what level I must upgrade the old FC switch in order to eliminate the problem?
11-08-2009 10:38 AM
Notice: The information in this Contribution is provided from following site: http://www.redbooks.ibm.com/abstracts/tips0038.html?Open without warranty of any kind.
This material has not been submitted to any formal IBM test and is published AS IS. It has not been the subject of rigorous review. IBM assumes no responsibility for its accuracy or completeness. The use of this information or the implementation of any of these techniques is a client responsibility and depends upon the client's ability to evaluate and integrate them into the client's operational environment.
Zoning conflict indicates that in new switch is active zoning confguration.
Zoning of switch you are adding should be cleared. This can be done by following this process:
11-08-2009 08:29 PM
Supported Products and FOS Interoperability
Silkworm 3014, 3016, 3250, 3850 and Brocade 3900, 4100,
24000, 7500, 7500E, 4012, 200E, 48000
are supported whit "v5.1 and higher"