01-11-2011 03:38 AM
Hello i'm newbie in Brocade. We have 2 brocades SilkWorm 200e, on of them was never configured and i successfully setup IP address for it using EZswitchsetup, after that get access to webtools and everything ok. Second one brocade was configured (i can't contact this person) and i can't even ping it, so i connect to it using serial cable and get access to it over console (using hyperterminal on windows 2003).
I've checked that it's network settings are correct (with ipaddrshow).
I've checked ipfilter on it and see that it not block any services:
Then i compare results of "configshow"on both brocades and all strings are the same, but i still can't even ping it.
Can you plz advice how to troubleshoot this issue?
Tanks in advance.
01-11-2011 04:33 AM
I would first disable ipfilter completely, to be sure there's no IP / LAN issue.
Hope this helps
01-11-2011 04:52 AM
Can you plz tell me how to make it? I saw i can only activate policies, but didn't see deactivate commands. BTW since i already wrote i'm a newbie, i don't want to delete these policies ( it will be a bit complex to create them else one time), but of course if there no way to do that i will.
01-11-2011 05:06 AM
I've verified on one of my switch, it seems I've the same configuration for ipfilter, which is the default one. Thus ipfilter issue seems to be a wrong way, I apologize.
When logged in on console, are you able to ping to default gateway ?
01-11-2011 05:25 AM
Ping command is not presented in this fabric os:
01-11-2011 05:33 AM
Here it is:
01-11-2011 05:35 AM
BTW i've checked that ethernet switch, where brocade is connected didn't see mac address of brocade (i already checked that port on switch is helthy)
01-11-2011 05:36 AM
you should either upgrade to 6.3.x or use root account to have ping available
ping 192.168.1.251 should work. If not it's a LAN issue.
01-11-2011 05:41 AM