02-05-2013 03:10 AM
Following a number of issues we have had on an ISL that runs between to 48000 and a dcx, we have been told to disable QOS on the concerned ports.
The ISL is formed from two links, so is a trunk.
Is it best practice to disable QOS on ISL links?
02-05-2013 08:37 AM
QoS should be configured on the ISLs when you use QoS zones. If you're not using QoS zones, there is no need to configure QoS on the ISLs, since there are some VC reserved for QoS High and Low priority zones that are not used.
02-05-2013 12:30 PM
I have ran into this issue before with ISL Links and was told by Brocade support to disable QoS on the ISL ports to prevent errors. One thing to keep in mind is that with ISL links it is best to keep them on the same ASIC on a blade when possible to prevent buffer credit to zero counters from incrementing on the ports.
As has already been stated unless you are using QoS Zoning there is no need for QoS on your ISL ports.
03-12-2013 09:03 AM
When there is a BB credit lost in a ISL, the only way to recover it back is to reset the port. And this is what Credit Recovery feature does. Without it, if you lose a BB credit (due to a physical issue for example) you wouldn't notice and the performance may be affected. I would not disable it unless there were a good reason to do it.