01-30-2010 11:57 AM
Hi, We have two Switches 3800 with Fabric OS: v3.1.3.
The problem is with telnet and SSH interfaces, the GUI work good.
I conect a PC direct to Etherneth port and the problem is the same.
You know if the problem is with OS, We can conect only by serial port and GUI interface.
01-31-2010 08:58 AM
We try to conect to Telnet or SSH session from the network without success.
After this We try conect a pc direct to ethernet port and the problema is the same on both switches.
The GUI from explorer working good.
After I conect to serial port and see if there a command to reset this services or port but I can not see this options.
The question is if there a command o process to restore this services.
02-02-2010 02:05 AM
I'm not sure if this is the correct command, i don't have any 3.x switch here and cannot test.
plug a serial cable, log as admin, and try "configure"
System services (yes, y, no, n):
check the feature called
telnetd (on, off)
if this is set to off, set to on, press enter to save
let me know.
02-02-2010 09:45 AM
the command work as online and offline, but some Feature can only be enable or disable when the switch is set disable, "switchdisable"
as i say in my preview post, you have to test please, because i don't have here any Old Switches which support FOS 3.x and cannot test it.
02-02-2010 03:42 PM
The update is next.
To moment to apply configured command from serial port and use th admin user, the system send the next messages:
configure: This command may not be executed on an operational switch.
You must first disable the switch using the "switchDisable" command.
I take te next information, maybe this help.
Command help and the input configure.
02-02-2010 10:52 PM
as mentioned in my preview post, I'm not sure if this feature telnetd is available and can be enable/disable in FOS 3.x
it is a long time i work with 4.x switch.
disable the switch "switchdisable and try again the command "configure"
System services (yes, y, no, n): y
rstatd (on, off):
rusersd (on, off):
let me know.