02-13-2013 05:49 AM
Can someone assist\help me in "how to configure SNMP Trap using a Private String on a standalone Brocade switch ?
Firmware : 7.xx
I am getting error message below:
02-13-2013 09:13 AM
Hi vikas.mattu. I'm not an expert by any means on this issue, but could you specify where exactly you are getting an error message please?
02-15-2013 02:44 AM
I get below message even after changing the community string to Private.
SNMPTRAP: -c public unknown 126.96.36.199 fswitch_4 6 4 0:00:00 4 OID:
when i change the Community string to private i should get acknowledment about private not public.
below is the setup