04-30-2017 08:12 AM
Recently I have done a FOS upgrade of DCX8510-8 switch from 7.3.1a to 7.4.1e. The firmware got sucessfully committed to Active CP, but standby CP got faulted during upgrade. After replacing the stand CP with new and FOS upgrade ,the timezone in both active and standby was different. Active was in IST time zone and standby in GMT zone and also few seconds time difference for active and standby even it have a NTP sync. Before FOS upgrade both active and standby CP had same timezone and timing. Please help me how it can resolve.
Thanks in advance.
Regards / Rahul Udayabhanu
Solved! Go to Solution.
05-02-2017 12:18 AM
I assume the CP are in sync (haShow)?
Concerning the timezone differnece - Have you tried by setting the time zone of the active CP to GMT and then back to IST to see if the change is then propagated to the standby CP?
05-02-2017 02:52 AM
Thanks for the reply.
Yes, both CPs are in hasync.
Local CP (Slot 6, CP0): Active, Warm Recovered
Remote CP (Slot 7, CP1): Standby, Healthy
HA enabled, Heartbeat Up, HA State synchronized
Tue May 2 15:20:14 IST 2017
Tue May 2 09:50:14 GMT 2017
I didn't tried the time time zone changing in Active CP. I will try to do this based on my internal change approvals.
05-13-2017 10:26 PM
As per the OEM analaysis we have done a stand by CP reboot. After that both standby and Actice CP is same time and time zone.