05-20-2008 06:14 AM
We try cascade Mcdata 4500 firmware 9.01.00 and Brocade 4016 v5.0.5 but it fail if "Safe Zoning mode" enable at Mcdata, it can cascade if disable "Safe Zoning mode", is it must disable "Safe Zoning mode" ? What useful about "Safe Zoning mode", thanks.
05-20-2008 07:01 AM
in this case, you must disable Safe Zoning, otherview the both Switch cannot comunicate. The reason is here the Security beetwen both OS Brocade and McDATA.
--->>> What useful about "Safe Zoning mode",
Safe Zoning Mode - When Safe Zoning Mode is enabled, zone sets from
different fabrics that do not match will be prevented from merging.
Consequently, an active zone set is protected from being modified when a
switch joins a fabric.
To configure optional security features, refer to the Brocade EFCM Basic Edition User Manual
05-22-2008 11:25 PM
Thanks your reply. Can it re-enable "Safe Zoning mode" after zoning merge? I check the EPORT is unnormal after re-enable it. I check Bocade Fabric OS document and some skilworm must disable first and it can re-enable "Safe Zoning mode". Thanks.
05-23-2008 02:50 AM
--->>> I check the EPORT is unnormal after re-enable it.
You must make sure that all Fabric Parameter ( R_A_TOV, E_D_TOV, Domain ID, Interop-Mode etc.... ) are set correct, i assume this is the reason why you get unnormal after re-enable safe zoning mode.