06-28-2018 05:38 AM
I've two Brocade 510 switches configured in replica through the port 0. It was working fine since we had a phisical issue with the fibre cable between the two switches. Meanwhile the issue was occurring, we needed to add new zonning to the configuration of the switches, so we did it in both switches instead of doing it in only one (due to the replica was not working).
Now the issue is solved and the link between both switches is up again, but the replica is not working. I get this message:
Index Port Address Media Speed State Proto
0 0 150000 id 4G Online FC LD E-Port segmented,10:00:00:05:1e:7e:39:8c (zone conflict)(Trunk master)
Is there any way to force the config in Switch1 sync with Switch2 to have sync again?
Solved! Go to Solution.
06-28-2018 06:04 AM
06-28-2018 06:42 AM
06-28-2018 07:25 AM
06-28-2018 07:48 AM
Yes, I've extracted the command "zoneshow" via putty of each of two switches and compared it with Notepad++ Compare plugin. The only differences between two files is the order of few zonnings.
06-28-2018 09:47 AM - edited 06-28-2018 09:48 AM
I can confirm that the order is really important.
Even if you have in one switch:
ZoneA with MemberX and MemberY
- but in another switch:
ZoneA with MemberY and MemberX
- that is already mismatch and will lead to segmentation.
Likewise, the list of zones in a config should be exactly the same on both sides.