03-15-2011 08:34 AM
The 200E Brocade configuration in Native interopmode and Cisco MDS 9124e HP is interopmode "2", in the Brocade no allow save the Zones. In the messages show Disable RCS. How must configuration the Brocade?
Brocade 200E firmware: v6.2.2b
Cisco MDS 9124E HP firmware: 4.0.x
03-16-2011 06:34 AM
As far as I know off, you're only option is too set the brocade switch in agmode (keep in mind it will lose its config and you need to check your mappings) and connect it the your cisco switch on a port with NPIV enabled.
From now on zoning is done on your Cisco only.
03-17-2011 03:59 PM
Ok as I understand you can't or won't convert the 200e in AG mode.
Perhaps its possible to put the Cisco switch in a similair mode, but I do not know if this is possible and how to do it if it is.