11-16-2015 11:43 AM
I'm new to Brocade switches and I'm trying to do the initial configuration on the DCX. All of the commands for configuration don't work on a CP if it's in standby mode. How do I switch a CP from being Stanby and make it Active so I can run the commands I need to and switch it back, if I wanted to?
11-16-2015 11:48 AM
don't worry, your switch work fine.
in director class switch, only one CP is active and the other is on standby.
this is the reason that you cannot execute some command on standby CP.
11-16-2015 12:13 PM