07-22-2008 03:11 PM
Can anybody tell me how to change, from command line or web interface, the IP address of the management station for a McData switch?
I mean, when you execute a "show switch" command, you get an output like:
Preferred Domain ID: 11
Switch Priority: Default
Rerouting Delay: Disabled
Interop Mode: Open Fabric 1.0
Active Domain ID: 11
World Wide Name: 10:00:08:00:EE:DD:UU:KK
Insistent Domain ID: Disabled
Domain RSCN: Disabled
Zoning RSCN: Enabled
FC Address Domain: 6b (hex)
Limited Fabric RSCN: Disabled
Zone FlexPars: Fabric Filtering
RSCN Zone Isolation: Fabric Filtering
Safe Zoning: Disabled
ISL FSPF Cost: By Port Speed
Web Enabled: Enabled
API Enabled: Enabled
API Management IP: 192.168.215.46 (<<<< this one!)
And in the last line is the IP address I want to change.
As I can see in the CLI user's guide (in the pdf document "Brocade M-EOS Command Line User Guide"), you can set config.switch.apiState in "enable" or "disable", but I cannot find where to configure the IP address of the server where management software runs.
Any hint will be appreciated very much.