03-04-2011 08:47 AM
I am trying to do an SNMPwalk of a logical switch within a DCX. It only seems to be returning the ports that are not assigned to a logical switch. These are the unused ports. I have disabled SNMPv3, double checked the Access Control list, and have tried multiple community strings. I have also tried SNMPwalk against the physical switch IP and end up with the same results. Does anyone have an idea of what might be going on here?
Here is the command I am running:
snmpwalk -v 2c -t 10 -r 2 -c <community_string_of_switch> <ip_of_switch> 220.127.116.11.3.94 >snmpwalkv2.log
I am trying to gather information on the ports that are in use. Specifically port performance.
Any help you can provide would be greatly appreciated.
03-04-2011 11:05 AM
As far as I know Virtual Fabric needs SNMPv3.
A query looks like this
snmpwalk -v 3 -u admin -c public IP -n VF:FID yourOID
IP with your IP
FID with the Fabric ID you would like to read
YourOID with the OID string you are looking for-
I hope this helps,
03-04-2011 11:54 AM
Does the model number of the DCX matter? I am pulling data from a few other DCX's just fine, but a couple of mine are not and the configurations look the same from what I can see. Do newer DCX's prevent data from being collected via SNMPv2C?
I appreciate the help.
03-05-2011 08:34 AM
you talk about logical switches and I assume that VF is enabled.
Switches with VF enabled needs SNMPv3 to work correctly and to be able to get SNMP data from logical switches as well.
Switches without VF enabled can be queried by SNMPv2.
Brocade does NOT support SNMPv2!
I hope this helps.
03-07-2011 01:46 PM
Thanks for the information. I'll do some SNMPv3 queries and get the data I am looking for. You are correct we are using Virtual Fabric on these specific switches.
03-08-2011 12:44 AM
good to hear that my assumtions were correct ;-)
I hope that you get the information you are looking for.
By the way, if you are looking for Nameserver entries be carefull some FOS codes didn't report the first entrie of the Nameserver.
This is a known DEFECT.
If you need further help, please let me know.
I would appreciate if you mark the thread as answered or correct.