For more details, please see ourCookie Policy.


Fibre Channel (SAN)

Reply
New Contributor
Posts: 2
Registered: ‎01-23-2012

Brocade 300 lost configuration during firmware upgrade

Hello,

During firmware upgrade from v6.3.1b to v6.4.1b of Brocade 300 lost configuration and there was a few minutes of traffic lost.

I did configdownload and seems everything ok (checked with fabricshow and zoneshow), but I'm not sure because I'm new with SAN.

Is there a way to see in logs reason for this config lost?

How can I make sure that config is properly downloaded?

Thanks.

Regards,

Marko

Valued Contributor
Posts: 761
Registered: ‎06-11-2010

Re: Brocade 300 lost configuration during firmware upgrade

try errdump -a to see if  the switch reported any kind of issue during the upgrade.

An easy way to check if config was applied with success is performing a new configupload and compare the current config file and the one you applied.

Join the Broadcom Community

Get quick and easy access to valuable resources across the Broadcom Community Network.