07-14-2017 09:04 AM
I stacked some Brocade ICX 6430-48P units in a test environment with the 10G-SFP-TWX-0101 stacking cables.
It works perfect; however, I do notice one thing:
ICX6430-48P Switch#sh medi e 1/2/1
Port 1/2/1: Type : 10GE Passive Twinax 1m (SFP +) (Not supported)
Vendor: BROCADE Version: A
Part# : 58-1000026-01 Serial#: CAMD1639001xxxx
ICX6430-48P Switch#sh stack
T=17m4.8: alone: standalone, D: dynamic cfg, S: static
ID Type Role Mac Address Pri State Comment
1 S ICX6430-48P active 748e.f8bd.xxxx 128 local Ready
2 D ICX6430-48P standby cc4e.24af.xxxx 0 remote Ready
-2/3| 1 |2/1--2/3| 2 |2/1-
| +---+ +---+ |
Standby u2 - protocols ready, can failover
Current stack management MAC is 748e.f8bd.xxxx
Should I be worried about this?
07-24-2017 09:14 AM
Cable is definitely supported for stacking according to data sheet so probable nothing to worry about
You could open a case with technical support to fully check this over
07-25-2017 08:38 AM
Thanks. I am doing that today after-hours to rob some SX SFP's for another one of my many employeer's sites.
Looks like I am replacing 16 switches.
Not lookign forward to it, but thanks.