Ethernet Switches & Routers

Sample Configurations for FI-SX, ICX6450 and ICX6610

by serhat.kahraman on ‎11-10-2012 11:26 AM (1,339 Views)

Hi,
Two SX chassis in MCT mode, ICX 6450 switches  and an ICX6610 switch.
This setup is tested for a PoC.
topology.jpg

Device configurations  are also attached in order for you to compare with topology drawing above.
if you have similar implementation, hope this information helps.


(Note: attached file is a rar file please change the extension)

Comments
by jch
on ‎05-16-2013 01:39 PM

I don't see rar file of configurations.

Any idea how to overcome this issue:  Modify cluster vlan range or VLAN port membership and then retry configuration

This is when adding "client-interface link-aggregation ethernet 1/1/7 to 1/1/8" to a client configuration under my cluster which is two ICX6650s.  Eth1/1/7-1/1/8 would be the client.

by
on ‎06-27-2013 07:31 PM

Hi Serhat,

     I think this would be very helpfull to some people, however the RAR file is missing as stated by jch.

     Save the attached conf.jpg file and rename to conf.rar - config are in there.

Thanks

Michael.