08-15-2014 12:33 AM
anyone connected a C WLC4404 to a icx or fdx ?
Normally the c config was mode on for the wlc. in icx i only have dynamic or static.
Dynamic blocks all LAG ports and static work for the half of the ips on the wlc :)
So currently iam looking for a working config with 8.0.10d
Thanks for Feedback
08-19-2014 01:02 PM
Not a 4404, but I do have 5508's off an ICX 6610, from what I remember the 4404's didn't support LACP and can only be setup as a static LAG
My suggestion is to config as a static trunk, once configured reboot your 4404, I know my 5508's require a reboot for changes to take effect to LAG's sometimes.
We are using 7400c code, this config works on 7400c, but would not work on 8.0+ code, worst case you may be able to downgrade your ICX
trunk ethe 1/1/1 to 1/1/2 ethe 2/1/1 to 2/1/2
port-name "WLC51" ethernet 1/1/1
Trunk ID: 1
Hw Trunk ID: 1
Primary Port Monitored: Jointly
Ports PortName Port_Status Monitor Rx_Mirr Tx_Mirr Monitor_Dir
1/1/1 WLC51 enable off N/A N/A N/A
1/1/2 none enable off N/A N/A N/A
2/1/1 none enable off N/A N/A N/A
2/1/2 none enable off N/A N/A N/A