05-16-2017 06:04 AM
I am currently working on aproject and need to stack three switches. I have done this with Ciso equipment before, but I am struggling with this one and cand find no documentation for the 7150 and stacking. Thank you.
Solved! Go to Solution.
05-16-2017 06:59 AM
The stacking procedures are similar to the 7450 stacking guide. Please download from the ICX 7450 0860 manuals on the My Brocade website. This will get you going.
05-16-2017 07:11 AM
I have tried to go based off of the 7450, 7350, and 7250; it says there are two options to configure it manual or secure stack. I have tried both and through both ways the commands those process use are not recognised through my 7150. I cannot do the stack enable command, the default-ports command, also it says the stacke secure-setup is an unrecognized command also.
05-16-2017 10:02 AM
I have not, but I just received 77 Ruckus ICX7150-48P-4X1G switches...
I might bring two up to my desk to play around with them once I get out of a meeting.
Anyway, you should be able to do an enable stack, setup hitless-failover, and a secure stack setup... I have NOT done it on this model, so I will write back in a bit.
05-16-2017 10:37 AM
Which ports are you trying to use? Which model of the 7150 do you have? The default stacking port for the 24, 24p, 48 and 48p are:
x/3/1 and x/3/3. The default stacking ports for the 48zp are x/2/1 and x/2/3. With the 7150, you dont need to uss "stacking unit <id> default-port" because the default ports are set.
Remember, all units must have the same version and licenses to be operational.
05-16-2017 11:52 AM
Aren't these supposed to be stackable via ethernet cables?
Also, there appears to be no "stack secure-setup" or "stack enable."
mac stacking MAC address
unit Configure local parameters for a stack unit
ICX7150-48P Switch(config)#stack enable
Invalid input -> enable
Type ? for a list
ICX7150-48P Switch(config)#stack secure-setup
Invalid input -> secure-setup
Type ? for a list
The folks on the phone tell me they "might" release a new version of the OS on June 30th that ads stacking.
05-16-2017 04:12 PM
According to the roadmap which I hae seen version 8.0.61 will add the following features and will ship in July 2017
• Stacking support
• Layer 3 capabilities
• ISSU (in service software upgrade for a stack of ICX 7150)
• VRRP and VCT