05-19-2012 08:10 AM
I have two XMR routers and am needing to send the full BGP routing tables instead of default. I am having trouble finding documentation
on doing this. Could someone point me in the right direction?
05-22-2012 09:52 PM
Sorry for the delay. I am new to Brocade so i tested this with a router not yet deployed.
This worked for me for eBGP on the Brocade:
neighbor 184.108.40.206 remote-as 3043
address-family ipv4 unicast
I added the following route before it showed up on the other side as this block wasn't being used.
ip route 220.127.116.11/24 null0 16
I am sending full routes from the cisco on the other side:
telnet@phx4-c134-agg# sho ip bgp sum
Router ID: 18.104.22.168 Local AS Number : 6086
Confederation Identifier : not configured
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 1, UP: 1
Number of Routes Installed : 389394
Number of Routes Advertising to All Neighbors : 1
Number of Attribute Entries Installed : 63538
Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend
22.214.171.124 3043 ESTAB 0h 6m26s 389393 0 1 0
Let me know how it works.