For more details, please see ourCookie Policy.

Ethernet Switches & Routers

Posts: 1
Registered: ‎12-12-2016

Adding AT&T ASE Circuit to a 7750

I am attempting to install a new AT&T ASE circuit on a Brocade 7750.  I have set up a VLAN with three untagged ports.  The ASE circuit in connected one port, the other two connect to my FortiGate firewall primary and backup.  It is not working.  AT&T states that they see no Layer 2 traffic.  Do I need to configure these three ports to handle Layer 2? 

Former Brocadian
Posts: 102
Registered: ‎02-04-2015

Re: Adding AT&T ASE Circuit to a 7750



Have you tried to check the MAC table and seen if you are seeing any on the port connected to the circuit, and the fortigate ports?!


You can check if "route-only" is globally enabled. if it is, then try disabling it under the designated ports.


Let me know how you get on.


Kind Regards,


Any and all information provided by me is not reviewed, approved or endorsed by Brocade and is provided solely as a convenience for Brocade customers.

All systems and all networks are different and unique. If you have a service affecting network problem, please open a TAC service request for service through Brocade, or through your OEM equipment provider. If this provided you with a solution to this issue, please mark it with the button at the bottom "Accept as solution" .

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.