Ethernet Fabric (VDX, CNA)

Reply
Regular Visitor
Posts: 1
Registered: ‎05-12-2016

Show port-channel

Hi all,

 

What does it mean by the sync: 1 and sync: 0 highlighted below:

 

SDC_CORE_VDX8770# show port-channel 12
LACP Aggregator: Po 12
Aggregator type: Standard
Ignore-split is enabled
Admin Key: 0012 - Oper Key 0012
Partner System ID - 0x0001,50-65-f3-fb-48-8d
Partner Oper Key 0005
Member ports on rbridge-id 36:
Link: Te 36/0/10 (0x250C016000) sync: 1 *
Link: Te 36/0/11 (0x250C018000) sync: 1

Member ports on rbridge-id 37:
Link: Te 37/0/10 (0x260C016000) sync: 0
Link: Te 37/0/11 (0x260C018000) sync: 0

 

Thank you.

 

Warmest regards,

GuoHan

Contributor
Posts: 66
Registered: ‎02-25-2016

Re: Show port-channel

[ Edited ]

Your ports with sync 0 are down or not correctly configured. 

 

Run

show interface tengigabitethernet Te 36/0/10
show interface tengigabitethernet Te 36/0/11
show interface tengigabitethernet Te 37/0/10
show interface tengigabitethernet Te 37/0/11
show running-config interface tengigabitethernet Te 36/0/10
show running-config interface tengigabitethernet Te 36/0/11
show running-config interface tengigabitethernet Te 37/0/10
show running-config interface tengigabitethernet Te 37/0/11
show running-config interface port-channel 12
show port-channel detail
 

 

Regards
Jörg Kost
Occasional Contributor
Posts: 7
Registered: ‎05-12-2016

Re: Show port-channel

Hi Kost,

 

Thank for your reply.

 

 

Does it possible to be this port channel running on active-standby mode? in stead of active-active?

 

Thank you.

 

Warmest regards

GuoHan

Contributor
Posts: 66
Registered: ‎02-25-2016

Re: Show port-channel

I doubt so. You could configure a primary or backup port but then there should be still LACP frames running over the interfaces. What is the device on the other "end"?  Is the link up on both member interfaces?

Regards
Jörg Kost
Occasional Contributor
Posts: 7
Registered: ‎05-12-2016

Re: Show port-channel

Hi J.Kost,

 

The other end is a physical server, which is not maintain by me.

I just need to clarify this about the meaning of sync in show port-channel command.

 

Then I guess at the server end is running in active-standby mode instead of active-active.

 

Thanks a lot.

 

Warmest regards,

GuoHan

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.

vADC is now Pulse Secure
Download FREE NVMe eBook