11-24-2015 04:54 AM
I have configured 2 VDX6740 to be a VCS cluster.
How to reset it back to factory default settings?
Both VDX6740 has been in the sam VCS ID and has been in the same cluster.
I've tried to reset it using command:
copy default-config startup config
no vcs vcsid 100 logical-chassis enable
But both VDX6740 are still the same, they were not successfully reset back to factory default configuration.
I've tried turning off the other one VDX6740 and do command above, but still no success to reset it back to factory default configuration.
The VDX6740 are still in testing environment.
Very appreciate for help about thi from any of you.
12-20-2015 08:11 PM
If you have physical access to these switches. Disconnect the cables connecting these switches. and then do the following commands
switch#copy default-config startup-config
and reload the swtiches
because when you do it while they are connected, they get the configuration from VCS fabric.
so isolate them first and then reset them to default.