turn on suggestions
![]() Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
|
04-12-2013 11:03 AM
I'm attempting to configure a monitoring session on the VDX but running into the dreaded:
% Error: Destination port cannot be in L2/L3/Qos/ACL/802.1x/LAG member/Lldp/Port-profile/non-default-MTU
I realize to fix this we need to "disable LLDP on the destination port". However, this is the first time I've had to do this on a VDX. I would like to verify how this is done before I go poking around in our production switch.
Can anyone provide insight into how to safely disable LLDP on a tengig port without affecting any other ports in the switch?
Thanks.
-Brian
04-12-2013 11:18 AM
never mind... hahaha
in the interface config mode...
(conf-if-te-...)# lldp disable