03-31-2017 06:07 AM
I have some ICX6430-48 as edge switches in my company,
the scene and the situation as below:
A PC's NIC configurated to autonegotiation is connected to our switch port configured to 100M-full,
the information on switch show command is 100M-full with no doubt,
but when i saw the PC configuration, it shows 100M-half.
my question is, one is set as auto and the other is set as fixed speed/duplex, May not Brocade correctly negotiate with NICs made from certain vendor?
or it's just a basic knowaledge that is not allowed to do like that?
thank you all in advance, best regards!
Solved! Go to Solution.
03-31-2017 07:23 AM
If you want to use auto-negotiation then both ends must be set to auto-negotiate (switch and PC).
If one end is set to s specific speed then both ends must be set manually