04-23-2014 01:50 PM
I am afraid I've screwed up upgrading the firmware on one of our serverirons. I've successfully upgraded the main flash, but from some reason the wsm flash is empty. the system is now stuck after boot saying "WSR initialization in progress. Please wait..." but it never completes. I cannot enter enable because of that. Is there any way to fix this?
ServerIronGT C-Series>show flash Active management module: Code Flash Type: AMD 29LV033C, Size: 64 * 65536 = 4194304, Unit: 4 Boot Flash Type: AMD 29LV040B, Size: 8 * 65536 = 524288 Compressed Pri Code size = 5652927, Version 10.2.00eTD4 (foundry/WXR10200e.bin) Compressed Sec Code size = 5644121, Version 10.2.00dTD4 (foundry/WXR10200d.bin) Maximum Code Image Size Supported: 6946304 (0x0069fe00) Boot Image size = 290596, Version 09.03.00 (m2b09500.bin) INFO: empty config data in the primary area, try to read from backup INFO: empty config data in the backup area also Configuration Data Flash is empty. Used Configuration Flash Size=0, Max Configuration Flash Size=327680. WSM module slot 2 CPU 1: Code Flash Type: , Size: 0 * 0 = 0 Boot Flash Type: , Size: 0 * 0 = 0 Compressed Pri Code: size = 0 Version Compressed Sec Code: size = 0 Version Maximum Code Image Size Supported: 0 (0x00000000) Boot Image size = 0 Version Maximum Boot Image Size Supported: 0 (0x00000000)
ServerIronGT C-Series>en WSR initialization in progress. Please wait...
05-08-2014 01:14 AM
yes I did see it actually. I spent hours trying all possible options - removing the card, putting it in different slot etc. without any luck since the failed upgrade - so it is unlikely to be related to physical installation of the board as I've been reshuffling it hundred times without any joy.