For more details, please see ourCookie Policy.


Application Delivery (ADX)

Reply
Member
Posts: 1
Registered: ‎12-02-2009

PBR on ADX running L3 code and multi-tenancy

Dear all,

 

I'm running an ADX with a Layer 3 code and mutli-tenancy. So fare so good. In one of the tenant I would like to configure a PBR rule in order to make sure that packet from a specific subnet are going to hit the firewall on a dedicated Interface. I have configured the following:

 

access-list 10 permit 10.61.0.0 0.0.15.255
!
route-map map01 permit 10
 match ip address 10
 set ip next-hop 10.0.0.9

 

and at the global network I have added following configuration to activate PBR:

 

ip policy route-map map01

 

Am I doing something wrong, because the 10.61.0.0/20 subnet is still being routed through the standard routing table and does not match the access-list 10

 

Any feedback would be apreciated, thanks in advance.

 

Regards

Laurent

Join the Broadcom Community

Get quick and easy access to valuable resources across the Broadcom Community Network.