Virtual Router/ Firewall/ VPN

Reply
New Contributor
Posts: 3
Registered: ‎06-02-2014

nat arp entry

[ Edited ]

Hello,

 

I see that v5400 not add nat arp entry, I need setup some nat 1:1 with dedictaed ip. I put it in nat rule but vyatta not add in arp table, so it not works.... I found only solution, but not so good.... add these dedicated ips also on eth0.... but not good....

Is there some correct way ? Thanks

 

M.

Occasional Contributor
Posts: 9
Registered: ‎10-26-2011

Re: nat arp entry

I've been playing around with this today and this is the first issue I came across.  Was trying to get NAT working and I had the same experience where I had to add the translated IP address to the outside interface, but it doesn't seem right to me.  However, I couldn't get it to work any other way.  Don't suppose you ever came across a different way of doing this?

 

Regards,

Mark J.

 

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.