SAN Health Utility

Reply
New Contributor
Posts: 3
Registered: ‎06-06-2011

I'm trying to run SAN Health on 4 6547 switches that are part of an IBM flex system.

I can run the connectivity check just fine. Just fyi these switches are in Access Gateway mode. 

I can't get SAN Health to accept any name for the Fabric. So I can't pass the pre-flight check

Moderator
Posts: 202
Registered: ‎07-21-2009

Re: I'm trying to run SAN Health on 4 6547 switches that are part of an IBM flex system.

Hi Bruce,

Please make sure you are using the latest SAN Health, 4.0.3, available at http://brocade.com/sanhealth.

Any time SAN Health rejects a fabric name it will give the reason in the onscreen log. Look there for the reason. If you still have problems, send the log and relevant screenshots to shadmin@brocade.com and we will look into the issue.

 

Regards,

HealthAdmin

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.