02-17-2010 06:48 AM
Could you please save me from my stupidity
I'm trying to triger some action from specific alerts (sending an e-mail, executing a script, anything....) using the Event policies feature.
When I'm creating and configuring a response to an alert, nothing happens.
I want an action to be triggered on the following message:
"A fibre channel port changed its operational state;Port xx (xx) changed operational state to Offline"
So I created the following policy
Policy type trigger : Event
Event type: Device Status Event
Event Levels: INFO
Description Contains: "A fibre channel port changed its operational state"
Message ID: *left blank*
Name: my_switch_name (I tried with wwn and IP address too)
Duration: 5 minutes.
My policy is active.
I disable/enable a port on this switch a few times.
I see the alerts on the log
Could someone please help me to understand why nothing's working.
Thank you in advance
02-17-2010 10:32 AM
This question has been posted under the SAN Health Utility section which only applies to the SAN Health application (please see http://brocade.com/sanhealth for more info). You'll probably get a better response if you move it elsewhere.