Info & Feedback

Reply
New Contributor
Posts: 2
Registered: ‎03-19-2014

SAN Switch 300 power supply failed

I have a customer with a dead SAN Switch 300.  We suspect a failed power supply.  I have a new, replacement switch but rather than swap out a virgin, unconfigured switch I am wondering what others think about swapping the power supply from the new unit to the old unit.  Or, possibly swapping the memory card from the failed unit into the new unit.

 

The goal here is to preserve the customer's configuration and avoid reconfiguration.

 

Any thoughts?

 

There is another 300 switch on this SAN, would that config automatically populate to a new switch when added into the fabric?

 

It's been a while since I have had to work with a FC network.

 

Thanks in advance for any replies,

 

Dave

External Moderator
Posts: 4,788
Registered: ‎02-23-2004

Re: SAN Switch 300 power supply failed

To avoid confusion, Info & Feedback forum is intended for Posting Info and Feedback about the Brocade Community, and not for problem or question specific related to Brocade Product.

 

the same

 

http://community.brocade.com/t5/Fibre-Channel-SAN/SAN-Switch-300-power-supply-failed-any-ideas/m-p/57844#M19422

 

 

TechHelp24

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.