08-18-2014 09:44 AM
Hi guys ,
does anyone knows the 60-xxxxxx number for an FC16-48 blade ?
And why is the FC8-48E-blade ( 60-1001945-14) shown as FC16-48 in SANhealth-report ?
many thanks for your reply
Solved! Go to Solution.
08-19-2014 03:44 AM
thanks for your reply.
Here some details:
San Health Client 4.0.2
Report Builder 4.0.0
the following is listed in San Health report:
FC16-48 Slot 2 ENABLED BQB0411H02H 60-1001945-14
But I think this part-number belongs to a FC8-48E-blade ?!
Or am I wrong ?
08-20-2014 10:51 PM
I've diverse SAN-Health report from TWO of my Customer where i've made the Installation , and both customer have 48E Blade.
However in this both SH report I see as Part Number 60-1001945-16 and not "14"
I'm using same SH version, but we have here FOS 7.2.x.
can you please post output of "slotshow -m" ?
Note. from you name/surname, are you Germany resident ?
09-01-2014 09:20 AM
excuse me I was on vacation.
I think there was something wrong with the label on my FC-blade.
Here is the output of "slotshow -m "
Slot BladeType ID Model Name Status
1 SW BLADE 96 FC16-48 ENABLED
2 SW BLADE 96 FC16-48 ENABLED
3 SW BLADE 96 FC16-48 ENABLED
4 SW BLADE 96 FC16-48 ENABLED
5 CORE BLADE 98 CR16-8 ENABLED
6 CP BLADE 50 CP8 ENABLED
7 CP BLADE 50 CP8 ENABLED
8 CORE BLADE 98 CR16-8 ENABLED
9 UNKNOWN VACANT
10 UNKNOWN VACANT
11 UNKNOWN VACANT
12 SW BLADE 96 FC16-48 ENABLED
All the FC16-48-blades are listed with: Factory Part Num: 60-1001945-14
and I think this is the correct number for FC16-48.
..and yes I'm from Germany....
greetings and bye
09-02-2014 10:58 AM
is you question aswered now ?
if no, send me a email to abongiorno_at_techhelp24_dot_net with you phone number, I'm in Germany until September 8, I'll call you.