05-16-2017 01:49 AM
We have configued the SNMP v1 protocol on Brocade 6510 switch and it is discovered in the monitoring tool HP NMMi . this tool is managed by the Cutomer. Now we are testing SNMP traps and executed the below steps . Most of the MIBs are enabled on the switch
snmpconfig --show mibcapability
snmpconfig --set mibcapability -mib_name HA-MIB -bitmask 1
snmpconfig --enable mibcapability -mib_name HA-MIB -trap_name fruStatusChanged
snmpconfig --enable mibcapability -mib_name HA-MIB -trap_name cpStatusChanged
snmptraps –send -trap_name cp-status-change-trap –ip_address 10.44.7.9
However the moniotring tool has cnfirmed that , they havent received the Traps in the NMMi tool.
Are there any other steps be followed ?
05-16-2017 04:02 AM
your commands are correct, just tested.
What is the output after executing...?
snmptraps --send -trap_name cp-status-change-trap -ip_address xxxxxxxx
It should be:
"Number of traps sent : 1"
This confirmes that the trap left the switch.
There should be no other settings needed besides of course adding 10.44.7.9 correctly as a snmpv1 trap receipient on the switch.