Fibre Channel (SAN)

Reply
Occasional Contributor
Posts: 11
Registered: ‎05-26-2013
Accepted Solution

Power Off and Power Up procedure for Brocade SAN Director

Hi All,

 

We are going to relocate our SAN directors in to another RACK in order we need to know the standard Power off and Power Up procedures for Directors and also If any instructions to be followed during Relocation would be more helpful.

 

Thanks,

Nayab

External Moderator
Posts: 4,813
Registered: ‎02-23-2004

Re: Power Off and Power Up procedure for Brocade SAN Director

[ Edited ]

use the command "sysshutdown" to shutdown the FOS.

 

by 48000 and old Directors, wait for appr. 60 Seconds, and the power off the Switch.

 

if you have DCX, ( I've never test ) this shold Power Off by shutdown but I'm not sure. If no, use same procedure as 48K

 

after relocation you need simple to do Power-On

TechHelp24
Valued Contributor
Posts: 531
Registered: ‎03-20-2011

Re: Power Off and Power Up procedure for Brocade SAN Director

I confirm that DCX and 8510 chassis do not turn off by themselves on sysshutdown. So you should wait a while and then turn off the power supplies.

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.