Fibre Channel (SAN)

Reply
New Contributor
Posts: 2
Registered: ‎10-04-2011

Integrate 300 switch with zoning present into fabric


I have a Brocade 300 switch that has zoning on it. I would like to remove all zone config info and then integrade into our current fabric. next i would like to make this switch the primary switch.

what are the correct steps and commands to accomplish this?

Regular Contributor
Posts: 164
Registered: ‎05-11-2011

Re: Integrate 300 switch with zoning present into fabric

Hi Eric,

to remove the zoning from the B300 perform the following:

cfgdisable;cfgclear;cfgsave.

Then you can connect the B300 to your fabric. Please look if the Fabric merges.

What do you mean with "make this switch the primary switch"?

Do you want the B300 become principal switch?

If yes, then you can set the priority of the B300 to the lowest value.

fabricprincipal --enable -p 0x01 -f.

Be careful, because the -f option will force an Fabric rebuild immediately.

Regards

Ralf

Kind Regards
Ralf

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.