01-13-2016 09:53 AM
I have 2 new Brocade 300 and I connected them each other. I have whole required licences:
Fabric Watch license
Full Ports on Demand license - additional 16 port upgrade license
Enhanced Group Management license
8 Gig FC license
The switches have the same FOS 7.4.
The switches can see each other and in the Switch View I can see two switches under one Fabric.
The problem is that when I open the Zone Admin I can see ports only from local switch.
Please advise steps to see in Zone admin two swiches?
01-13-2016 10:04 AM
since you have create a Fabric trough ISL, you see only one config.
But I'm not sure what you mean with "I can see ports only from local switch"
can you please explain a bit more ?
01-13-2016 10:43 AM
When I open Zone Admin I have somethink like attachment.
In older configuration Brocade 300 + 200 in lower FOS I have posibility to choose in Zone Admin port or WWN from two switches. I have available them through Domain.ID.Port
So it's looks like:
Create zoning is then very simple and fast.
01-13-2016 03:04 PM
That's normal and Brocade's "friendly" reminder that there is a free version of BNA that helps you with that. Wasn't there even an advertizing in WebTools that this function went to BNA? So you have 3 possibilities:
- do it via CLI
- install BNA
- I think it should also work if you just create aliases on each switch and then zone the aliases (cannot check at the very moment)