Fibre Channel (SAN)

Reply
N/A
Posts: 1
Registered: ‎07-22-2008

How to change API management IP address on switch?

Hello:

Can anybody tell me how to change, from command line or web interface, the IP address of the management station for a McData switch?

I mean, when you execute a "show switch" command, you get an output like:

Switch Information

State: Online

R_A_TOV: 100

E_D_TOV: 20

Preferred Domain ID: 11

Switch Priority: Default

Rerouting Delay: Disabled

Interop Mode: Open Fabric 1.0

Active Domain ID: 11

World Wide Name: 10:00:08:00:EESmiley Very HappyD:UU:KK

Insistent Domain ID: Disabled

Domain RSCN: Disabled

Zoning RSCN: Enabled

FC Address Domain: 6b (hex)

Limited Fabric RSCN: Disabled

Zone FlexPars: Fabric Filtering

RSCN Zone Isolation: Fabric Filtering

Safe Zoning: Disabled

ISL FSPF Cost: By Port Speed

Web Enabled: Enabled

API Enabled: Enabled

API Management IP: 192.168.215.46 (<<<< this one!)

And in the last line is the IP address I want to change.

As I can see in the CLI user's guide (in the pdf document "Brocade M-EOS Command Line User Guide"), you can set config.switch.apiState in "enable" or "disable", but I cannot find where to configure the IP address of the server where management software runs.

Any hint will be appreciated very much.

Regards

Ignacio

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.