02-24-2010 08:16 PM
I have an HP Blade with the HP Brocade FC Switch, I cannot get this switch to see my Qlogic 5602 or anything plugged into the Qlogic switch.
Any help would be great,
02-24-2010 11:35 PM
1.Login into the CLI and type "switchshow"
2. See if you can see the HBA's WWN
3. If you can't then check your physical cabling & SFP's.
02-25-2010 05:03 AM
I ran that command and the 2 ports connected to me Qlogic switch show
17 17 id N4 In_Sync
18 18 id N4 In_Sync
they are blinking yellow on the Brocade and don't light up on the Qlogic,
02-25-2010 11:07 AM
which Fabric OS Rel. is loaded in the Brocade and which Firmware is Loaded in QLogic ?
In order to Interoperate Brocade to QLogic the ISL Port in QLogic must be set as G_Port, and in a Brocade switch must be set as E_Port.