11-23-2011 04:05 AM
We are connecting Qlogic CNA 8142 (Vmware ESX 5) to Juniper QFX3500 and from Juniper QFX3500 to Brocade 300.
Everything is set up like best practice in Juniper and the Juniper port is discovered in Brocade 300. But no FCOE traffic from the Qlogic.
We think we maybe need to change the FC-MAP on the FIP protocol in Juniper but where can i the FC-MAP in the Brocade 300?
11-23-2011 04:32 AM
Ignore please my preview Post, I remove this one.
I found this here, show to me as The QFX Port must be Set/Configured as N_Port.
can you point me to Juniper best practice if is one available on the WEB ?
11-23-2011 04:53 AM
verify that NPIV is enabled on 300's port (portcfgshow, 'NPIV capability') and that NPIV is configured on QFX3500. If yes, you should see CNA WWPN when running portshow on 300's port. You don't have to configure any mapping on 300.
Hope this helps