Fibre Channel (SAN)

Reply
Occasional Contributor
Posts: 11
Registered: ‎01-18-2013
Accepted Solution

F-Port Device update mode setting

Hi Team,

 

How to check if the fabric configuration parameter "F-Port device update mode" has been turned on or not in the DCX switches running FOS 8.0.1b without disabling switch and getting configuration mode.

 

Ganesh

Brocade Moderator
Posts: 278
Registered: ‎08-31-2009

Re: F-Port Device update mode setting

Hello,

 

This can be seen with configure command or configshow -all command.

Any and all information provided by me is not reviewed, approved or endorsed by Brocade and is provided solely as a convenience for Brocade customers. All systems and all networks are different and unique. If you have a service affecting network problem, please open a TAC service request for service through Brocade, or through your OEM equipment provider. If this provided you with a solution to this issue, please mark it with the button at the bottom "Accept as solution"
Brocade Moderator
Posts: 278
Registered: ‎08-31-2009

Re: F-Port Device update mode setting

The command to check the F-Port Device Update Mode status is: configshow -all | grep fabric.nport_10bit_upd_scn

 

 

fabric.nport_10bit_upd_scn:0 <<< F-Port Device Update Mode disabled

Any and all information provided by me is not reviewed, approved or endorsed by Brocade and is provided solely as a convenience for Brocade customers. All systems and all networks are different and unique. If you have a service affecting network problem, please open a TAC service request for service through Brocade, or through your OEM equipment provider. If this provided you with a solution to this issue, please mark it with the button at the bottom "Accept as solution"
Occasional Contributor
Posts: 11
Registered: ‎01-18-2013

Re: F-Port Device update mode setting

Thanks you so much Thierry

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.