02-22-2012 08:46 AM
All: You know when you make Cisco SAN Switch changes you have to finish up your session with: copy runnning to start Or something likek that. When you do a Brocade SAN Switch change with commands, do you have to finish up with anything to permanenetly save the config change? When I do zoning on the Brocade, I finish up with: cfgSave But I think that that is a zoning library database save, not an entire Switch configu save. I'm only setting "portcfgfillword". Stuart
02-22-2012 09:04 AM
No not really, most commands are effective immediatly.
Those who don't require a switchdisable or a portdisable/enable or something similiar.
The only command that comes close to Cisco's is they cfgenable to copy the defined zonset to the effective zoneset