12-19-2012 06:27 AM
When we use a switch in AG mode, for removing the mappings between F-port & N-port , I used the below two commands
ag --mapdel 30 "12;13"
ag --staticdel 30 "12;13"
Both these two commands do the same job, but what would be difference between these two ? Using "staticdel" is similar to using a "mapdel" ?
Can someone help me with this please
Thanks a lot for your time,
12-19-2012 11:35 PM
in the FOS Command Reference Guide there is written:
--mapdel N_Port F_Port1 Deletes one or more specified F_Ports from the "primary" N_Port mapping.
--staticdel N_Port F_Port1 Deletes a static mapping between an existing "primary" N_Port and one or more
specified F_Ports. This command removes exiting mappings. Alternately, you can
remove an existing mapping by mapping the F_Port to another N_Port.
So for the deleteing of the mapping it seems to be the same, but it is not. With staticdel you can only delete a "static F-Port" mapping between an N and F port and with the mapdel you can only remove "Configured F-Port" mapping.
Please use the ag --mapshow to see the differences.