Fibre Channel (SAN)

Reply
New Contributor
Posts: 2
Registered: ‎01-23-2012

Brocade 300 lost configuration during firmware upgrade

Hello,

During firmware upgrade from v6.3.1b to v6.4.1b of Brocade 300 lost configuration and there was a few minutes of traffic lost.

I did configdownload and seems everything ok (checked with fabricshow and zoneshow), but I'm not sure because I'm new with SAN.

Is there a way to see in logs reason for this config lost?

How can I make sure that config is properly downloaded?

Thanks.

Regards,

Marko

Valued Contributor
Posts: 761
Registered: ‎06-11-2010

Re: Brocade 300 lost configuration during firmware upgrade

try errdump -a to see if  the switch reported any kind of issue during the upgrade.

An easy way to check if config was applied with success is performing a new configupload and compare the current config file and the one you applied.

Join the Community

Get quick and easy access to valuable resource designed to help you manage your Brocade Network.