01-11-2013 08:02 AM
Hello, I've worked a lot with Cisco, but am new to Brocade. How can I do this on Brocade switches?
Here is an example of what I'm doing on a Cisco switch.
ip dhcp use subscriber-id client-id
ip dhcp pool Example
network 10.0.10.0 /24
ip dhcp excluded-address 10.0.10.48 10.0.10.255
address 10.0.10.1 client-id Eth1/1 ascii
address 10.0.10.2 client-id Eth1/2 ascii
address 10.0.10.3 client-id Eth1/3 ascii
address 10.0.10.4 client-id Eth1/4 ascii
address 10.0.10.48 client-id Eth1/48 ascii
int range eth1/0-48
ip dhcp server use subscriber-id client-id
Appreciate any assist you can offer.
01-11-2013 12:38 PM
Just to clarify a bit. I want to do DHCP locally on the switch. I want the switch to assign an IP address based on what port the device is plugged in.
I.E. if someone plugs into port 13 they get IP address 192.168.1.13
Is there a way to do this? I've tried googling for this, but I cant find the commands to do this on FCX?